nanoDLP

HI Shahin
I change the output of  on a video driver  ,on a computer that gave a black screen after the start (WIN XP32)
The first put the projector, the second monitor, and the monitor set the main
collected all the versions that I found on a computer and on a flash drive ,and one by one checked everything
those old versions that do NOT decrease on the first page, (where the log),,connection to the projector 
If the click is start, the cursor appears in the center of the projector , and can be moved to the monitor, and all the calibration grids work,
and write  "Initializing build # 0 - generic"
but other new versions that  ,reduce, they do not work correctly,, after click start, the cursor disappears,and  need to press the WIN  on the keyboard
and all versions are written 1635,1647, 1686 ,1695 ,1739 1744,,while printing is not yet check ,,tomorrow I will check all versions on another computer

Thank you

I have checked out code, for a long time there were no major change to windows build. Mentioned error is not important.
Could you upload version which works fine with your computer?, so I could check out which build is it.

Thank you.

You need to expand SD card.

HI Shahin
I checked version 1751, and also does not work
after the start of the display  need to press the WIN so that the cursor appears
I confirm the calibration, everything works, but through  2-3 minutes the projector is white,
video card driver updated
the bottom panel nano dlp  image viewer no answer write

and another problem appeared

I tested different versions and each time different, a cube, a star, a triangle, a rhombus
in the latest version, tested the cone, and when I put a print on the test
then the screen on the first page comes out image, from other versions, and they change
one cube, the second star the third cone,
and further, vary in different ways
I opened all versions, and deleted everything plates
once again cut the cone
but image they come again
I scanned the computer all the files of png--nowhere is there anything
where to get these images  nano ,I can not understand if I deleted everything
where is this file located
127.0.0.1:8080/static/plates/1/3.png

Last edited by elshad66 (2017-12-09 14:43:45)

I thought you shared it above!

HI Shahin

I formatted the computer and all cleaned,all previous versions collected in one archive
Did not connect to the Internet, installed everything through a USB flash drive,
and on a clean computer . I checked the latest version, can already print,there is already improvement  but there is a small problem
if click start, the cursor appears in the center of the projector,and on the bottom panel flashes blue 7 times  ''nanodlp  image viewer". and stop fire blue color
Мove the cursor to the monitor, calibration works, and can print
if by any chance,mouse click will get on the projector or the blue  ''nanodlp  image viewer", calibration  not works, and can"t print,,images do not go to the projector,,and ''nanodlp  image viewer" ,how everything is gray
To continue working,  need to restart  nano.exe

thank you very much for your attention
Elshad

Last edited by elshad66 (2017-12-11 06:33:19)

HI Shahin

still found that

if  gray ''nanodlp  image viewer" and calibration  not works
click start print and click  ''nanodlp  image viewer" ,it changes its color to white
and the image  layers goes to the projector,if  click on any part of the monitor, it changes its color to gray
and images layers do not go to the projector  ,,''nanodlp  image viewer" it works as an on / off switch

thank you very much for your attention
Elshad

Last edited by elshad66 (2017-12-11 07:50:08)