Terms of service
Brokking
 
 
.net
Let's keep it simple
 

 
   Home
   TL-blog
   Projects
 

   Articles
 

   Contact
   Donation
             
 
 

 
Brokking.net - Project building an electric skateboard - Home.

Project building an electric skateboard

It's done before. And it doesn't look difficult. So why make another project page about building an electric skateboard?

For me it's not about the speed. It's all about the technology. Trying something new and make it safe and reliable.

Click to see the full image

I will begin with defining some of the characteristics:
1) safe
2) easy and comfortable to use
3) remotely controlled

I already had a concept idea in my head for weeks. So I knew that the problem wasn't the conversion of the skateboard, it would be the remote. It has to be safe, small enough to fit in my pocket, comfortable to hold and it needs to display the battery status of the skateboard. This means bi-directional communication.


Download the schematics and Arduino programs here:

longboard.zip


Enclosure

Click to see the full image

Enclosure on Conrad

Funduino pro mini

Click to see the full image

Funduino Pro Mini Microcontroller on DealExtreme

5V step up booster

Click to see the full image

5V step up booster on DealExtreme

HC-05

Click to see the full image

HC-05 on DealExtreme

ACS712 20A Current Sensor

Click to see the full image

ACS712 20A Current Sensor on DealExtreme

And some other parts like a power switch, 330Ω resistors, 10k potentiometer, LED's, AA-battery, etc.

And with all the parts on my desk it's time to fit everything in the enclosure.

Now that the remote is finished it's time to rebuild the skateboard. The parts that I used for the drive train are:

Small pulley - 15 teeth

Click to see the full image

Small pulley - 15 teeth on Conrad

Large pulley - 60 teeth

Click to see the full image

Large pulley - 60 teeth on Conrad

Toothed drive belt 98 teeth

Click to see the full image

Toothed drive belt 98 teeth on Conrad

DC motor

Click to see the full image

DC motor on DealExtreme

Because the pulley is smaller than the wheel I needed to make an adapter ring. This is made out of 2mm carbon fiber. With the adapter ring in place I can now drill the holes in the pulley.

To make sure that the pulley was aligned with the wheel I made an 8mm axis that fit the wheel bearings and the pulley. I'm pretty convinced that four threaded rods are stiff enough to hold the pulley in place.

And with the toothed pulleys installed it is time to work on the motor mount. There are several ways to do this but I have chosen the most ridicules method ever...... glue.

I made the motor mount of 12mm plywood. By doubling the total thickness is 24mm. And it's holding pretty well.

And with all the parts in place it is time to test the board.