Forum

Welcome Guest 

Show/Hide Header

Welcome Guest, posting in this forum requires registration.
Pages: [1]
Author Topic: BUSY
bogus
Newbie
Posts: 4
Permalink
Post BUSY
on: December 7, 2014, 20:21
Quote

Hello Guys,
i'm trying to build a polargaph. Have a mac with snow leopard, ramps 1.4 and arduino mega. I have followed this guide https://github.com/euphy/polargraph/wiki

But when i start a command, the polargraph application says that it's busy. i have try to restart arduino, unplug arduino, but nothing happens. what i have to do?
sandy
Administrator
Posts: 1317
Permalink
sandy
Post Re: BUSY
on: December 7, 2014, 20:55
Quote

Hello. When you start the Polargraph Controller, does it connect at all?

Which firmware are you using?

I have just made a couple of modifications to the page, the main one is to recommend commenting out the line to disabled the touchscreen (https://github.com/euphy/polargraph/wiki/Using-the-Polargraph-software-with-RAMPS-motorshield).

I've also just added a new page:
https://github.com/euphy/polargraph/wiki/Machine-stuck-on-BUSY

sn
bogus
Newbie
Posts: 4
Permalink
Post Re: BUSY
on: December 7, 2014, 21:38
Quote

Thank you Sandy
Yes, it is connect at all.
I have uploaded 1.10 firmware. Now it works but only if i plug motor stepper on E0 and X axes. On X axes the motor doesn't work very well.

Ps: i followed the instruction on github that you have post.
sandy
Administrator
Posts: 1317
Permalink
sandy
Post Re: BUSY
on: December 7, 2014, 22:19
Quote

Ok so is this a different thing, or the same thing? Is your BUSY signal fixed? How did you fix it?

I updated the document on the wiki on github earlier to say

Motor A (left hand) is on the driver for E1, extruder 1.
Motor B (right hand) is on the driver for the Y axis.

https://github.com/euphy/polargraph/wiki/Using-the-Polargraph-software-with-RAMPS-motorshield#motor-assignations
bogus
Newbie
Posts: 4
Permalink
Post Re: BUSY
on: December 7, 2014, 22:35
Quote

Now It is all Fixed. thank you a lot Sandy. I have fixed all updating the firmware that you have posted on github, comment out #define USE_LCD. Motor A and B are put on E1 and Y axis and they work fine:)
sandy
Administrator
Posts: 1317
Permalink
sandy
Post Re: BUSY
on: December 7, 2014, 22:39
Quote

Hurray! That page needed some improvements - glad they were helpful.
bogus
Newbie
Posts: 4
Permalink
Post Re: BUSY
on: December 7, 2014, 22:41
Quote

Thanks a lot Sandy 🙂
Pages: [1]
Mingle Forum by cartpauj
Version: 1.0.34 ; Page loaded in: 0.037 seconds.