Forum

Welcome Guest 

Show/Hide Header

Welcome Guest, posting in this forum requires registration.
Pages: [1]
Author Topic: Make the 120mm y home configurable [solved]
simone
Newbie
Posts: 14
Permalink
Post Make the 120mm y home configurable [solved]
on: June 21, 2015, 20:58
Quote

Hi
foreseeing the build of a large polargraph (let's say a 3 meters wide machine), I was wondering whether making the 120mm y positioning of the home a configurable parameter was a legitimate feature request.
The maximum height of the drawing area is more related to the angle between cords than to an arbitrary difference between sprockets' y and home's y.
tx
Simone (yes, again..)
sandy
Administrator
Posts: 1317
Permalink
sandy
Post Re: Make the 120mm y home configurable
on: June 21, 2015, 21:08
Quote

The home point is already configurable - on the setup tab. When I run very tall machines (in windows), I usually place the home point down at the bottom, where I can actually reach it.

sn
Pages: [1]
Mingle Forum by cartpauj
Version: 1.0.34 ; Page loaded in: 0.032 seconds.