Forum

Welcome Guest 

Show/Hide Header

Welcome Guest, posting in this forum requires registration.
Pages: [1]
Author Topic: Motors doesnt move.
MrAlkoFigh-
ter
Newbie
Posts: 3
Permalink
MrAlkoFighter
Post Motors doesnt move.
on: March 14, 2016, 14:23
Quote

Hello, sorry interrupting you.

I use: Arduino Uno microcontroller (Iduino Uno Geeetech)
Adafruit motor shield v1
Polargraph_server_a1 software
Nema17 motors, 200 steps per revolution.

The problem is that the motors are moving, when I'm using arduino sketch.
After uploading polargraph software everything seems to be ok. The are "Polargraph READY! (uno)" green letters in the left corner of polargraph controller, after I'm choosing the COM-port.
But after pushing "SET HOME" button - nothing happens, after pushing "MOVE DIRECT" or "MOVE PEN TO POINT" nothing happen too, the motors doesn't block.
There is screenshot below of how console behaves on my commands.

That's my story. Will be gratefull for help.
Thanks a lot.
Image
sandy
Administrator
Posts: 1317
Permalink
sandy
Post Re: Motors doesnt move.
on: March 14, 2016, 14:26
Quote

Welcome 🙂 Have you started the command queue? (Click on the red writing at the top.)
MrAlkoFigh-
ter
Newbie
Posts: 3
Permalink
MrAlkoFighter
Post Re: Motors doesnt move.
on: March 14, 2016, 14:29
Quote

Lol! Thank you, Sandy)))
sandy
Administrator
Posts: 1317
Permalink
sandy
Post Re: Motors doesnt move.
on: March 14, 2016, 21:31
Quote

hee hee 🙂
Pages: [1]
Mingle Forum by cartpauj
Version: 1.0.34 ; Page loaded in: 0.033 seconds.