Forum

Welcome Guest 

Show/Hide Header

Welcome Guest, posting in this forum requires registration.
Pages: [1]
Author Topic: Der Kritzler using Polargraph Software
donald
Newbie
Posts: 5
Permalink
Post Der Kritzler using Polargraph Software
on: April 26, 2014, 19:32
Quote

Hi!

I made the kritzler, but i can't run a program of the Kritzler, unfortunately i don't know why...

http://tinkerlog.com/2011/09/02/der-kritzler/

Github:
https://github.com/tinkerlog/Kritzler

this is the circuit:
Image

Is there a way to use a PolarGraph software to drawing by kritzler?

help please!
donald
Newbie
Posts: 5
Permalink
Post Re: Der Kritzler using Polargraph Software
on: April 26, 2014, 20:50
Quote

here is the KritzlerShield arduino code:

// pin defines
#define MS1_PIN 2
#define ENABLE_PIN 3
#define MS3_PIN 4
#define SERVO_PIN 5
#define STEP_PIN_M1 6
#define DIR_PIN_M1 7
#define STEP_PIN_M2 8
#define DIR_PIN_M2 9
#define LED_PIN1 10
#define LED_PIN2 14
sandy
Administrator
Posts: 1317
Permalink
sandy
Post Re: Der Kritzler using Polargraph Software
on: April 27, 2014, 13:22
Quote

Hello, I'm going to trim those two posts right down to the important elements when I get home onto a proper computer. It shouldn't be a problem though. Having a quick look at the kritzler code, it seems to connect to the stepper drivers on pins 6, 7, 8 & 9, which are the same pins as the RAMPS board I think, so the changes that you've already seen on http://www.polargraph.co.uk/forum/polargraphs-group2/building-hardware-forum3/arduino-mega-2560r3-with-ramps-1-4-thread286.0.

That said, if you can't get the kritzler code running, then you won't get the polargraph code running if you use the same pin assignments. Looking at the photograph, it looks like the step and direction pins on the motor drivers are connected to pins 9, 10, 11 & 12, so that circuit is not the same as the kritzlershield circuit.

Sn
Pages: [1]
Mingle Forum by cartpauj
Version: 1.0.34 ; Page loaded in: 0.032 seconds.