Forum

Welcome Guest 

Show/Hide Header

Welcome Guest, posting in this forum requires registration.
Pages: [1]
Author Topic: Gondola moves double in the x direction
pantera102-
5
Newbie
Posts: 11
Permalink
Post Gondola moves double in the x direction
on: January 28, 2016, 17:50
Quote

Hello all,

So I went to messing with some settings to be able to have more drawing area. The actual machine width is all the same but now its acting very strange. I am using an 8ft(2438.4mm) x 8ft(2438.4mm) mounting board. From mounting the motors I have a machine width of 2337mm and a machine height of 2388mm. I am drawing on 4ft(1219mm) sheets of paper. All of these are correct. I have been using this same set up and it has been working very well for me. But since I messed with it and then tried putting it back the gondola is more or less moving double the distance and I cannot figure it out.

I'm sure it's just something simple as per usual.
I am saving and then uploading which seems to be the way it is supposed to be done.
Image
sandy
Administrator
Posts: 1317
Permalink
sandy
Post Re: Gondola moves double in the x direction
on: January 28, 2016, 19:32
Quote

PolargraphSDs usually have 200 steps per rev, rather than 400.

Best off editing your default.properties.txt file directly, and changing the 400.0 to 200.0.

sn
Pages: [1]
Mingle Forum by cartpauj
Version: 1.0.34 ; Page loaded in: 0.024 seconds.