Forum

Welcome Guest 

Show/Hide Header

Welcome Guest, posting in this forum requires registration.
Pages: [1]
Author Topic: One motor is loose second one is tense
ndz89
Newbie
Posts: 1
Permalink
Post One motor is loose second one is tense
on: September 24, 2013, 00:34
Quote

Hi.
First of all, thanks for such a great machine Sandy!
Now my problem.
I have Arduino Mega with Adafruit. Motors are working almost right but when they are still left one is tense (it "holds" the cord and it is hard to pull cord by hand) and the second one is loose (i can easily pull cord, there is no holding torque).
Any suggestions will be great:)
sandy
Administrator
Posts: 1317
Permalink
sandy
Post Re: One motor is loose second one is tense
on: September 24, 2013, 12:42
Quote

Difficult to say, but when this happens to me, it's usually because of a short between the motor coils. That is, the four pins that lead to the motor are pressed up against a metal surface, or something daft like that. Check your wiring I guess! Sorry that probably sounds pretty glib.

Try loading up the adafruit example sketches and see if there's any issue with those.

good luck!
sn
cadcoke5
Newbie
Posts: 6
Permalink
Post Re: One motor is loose second one is tense
on: November 26, 2013, 11:16
Quote

I realize this is an old thread, but was up early and looking for things to do. So, perhaps my comment will help someone in the future with similar issues.

Another potential failure for steppers is overheating, which can permanently damage the magnets. If your motor was purchased used, you don't know what situation it came from. It may have been given higher voltage than it should have. Another totally different possibility, is that the motor controller is not providing the current or voltage you need.

-Joe Dunfee
Pages: [1]
Mingle Forum by cartpauj
Version: 1.0.34 ; Page loaded in: 0.028 seconds.