Forum

Welcome Guest 

Show/Hide Header

Welcome Guest, posting in this forum requires registration.
Pages: [1]
Author Topic: Problem draw vectors and SD
soko
Newbie
Posts: 13
Permalink
Post Problem draw vectors and SD
on: February 9, 2018, 21:47
Quote

Hey everyone,

I built a polargraph with arduino MEGA R3, a cnc shield, a servomotor and two nema 23 steppermotors.

The arduino is powerd by a power supply of 12v 5A and a BEC convert 12v to 5v.

The system have a 2G SD and no screen.

When I generate the norwegian pixel technique ... everything works perfect.

But if I try to draw vectors ... with files that weigh 1 or 2 megabytes, the process break after starting at random points.

As a curiosity, if I touch the mass of the SD reader with my hand ... the work is resumed.

I suspect that it is some fault in the reading of the SD, did any of you have the same?

Thank you very much!
kongorilla
Pro
Posts: 362
Permalink
kongorilla
Post Re: Problem draw vectors and SD
on: February 13, 2018, 22:31
Quote

Does it work fine if you remove the SD reader and do everything over USB?
soko
Newbie
Posts: 13
Permalink
Post Re: Problem draw vectors and SD
on: February 15, 2018, 21:59
Quote

Yes ......only happen with SD
Pages: [1]
Mingle Forum by cartpauj
Version: 1.0.34 ; Page loaded in: 0.019 seconds.