Forum

Welcome Guest 

Show/Hide Header

Welcome Guest, posting in this forum requires registration.
Pages: [1]
Author Topic: Problem with the drawing area
DifentalRu-
s
Newbie
Posts: 5
Permalink
Post Problem with the drawing area
on: June 17, 2018, 15:05
Quote

Hello!
Help correct the situation
I select the drawing area in the controller that is within the page. But at the bottom the image is rounded, as if the controller limits it to a long cable from the motor. In this case, the image contour itself is well drawn.
Image
sandy
Administrator
Posts: 1317
Permalink
sandy
Post Re: Problem with the drawing area
on: June 17, 2018, 22:20
Quote

Hello! That is an odd one indeed!

This doesn't look like a huge machine, so the numbers shouldn't be high. But your grid size is currently 25 and it look very tiny on screen. What settings do you have on your machine (steps per rev etc)? You could give a shot of your "info" tab.

If you increase the grid size, does it "fill out" the corners? Just a thought.

sn
DifentalRu-
s
Newbie
Posts: 5
Permalink
Post Re: Problem with the drawing area
on: June 18, 2018, 13:04
Quote

Hi!
Thanks for the quick feedback!
In the attachment, photo settings of the controller and its version.
When you change the grid size, nothing changes.
my Machine is assembled on arduino mega 2560 with RAMPS 1.4. NEMA 17 motors are controlled by a4988 drivers.
Now I will try to use the controller of an earlier version. Suddenly this will help
DifentalRu-
s
Newbie
Posts: 5
Permalink
Post Re: Problem with the drawing area
on: June 18, 2018, 13:05
Quote

Quote from DifentalRus on June 18, 2018, 13:04
Hi!
Thanks for the quick feedback!
In the attachment, photo settings of the controller and its version.
When you change the grid size, nothing changes.
my Machine is assembled on arduino mega 2560 with RAMPS 1.4. NEMA 17 motors are controlled by a4988 drivers.
Now I will try to use the controller of an earlier version. Suddenly this will help

Image
Image
DifentalRu-
s
Newbie
Posts: 5
Permalink
Post Re: Problem with the drawing area
on: June 18, 2018, 13:07
Quote

Sorry for the chaotic writing and sending messages. I just can not get used to the algorithm of writing and attaching images)))))
DifentalRu-
s
Newbie
Posts: 5
Permalink
Post Re: Problem with the drawing area
on: June 19, 2018, 19:08
Quote

Hi!
When using the controller v 2.4 build 0, there was no problem.
So that. I will use this version.
Yes, and I also noticed a misunderstanding in all the controllers with my machine.
If you select "sawtooth" in rended pixels, the gondola walks along one line does not paint the pixels regardless of the selected grid parameters, etc.
All other drawing styles work well. test pen width also runs wonderful.
What could it be? Prompt good people.
It seems to me that "sawtooth" looks better than all
Pages: [1]
Mingle Forum by cartpauj
Version: 1.0.34 ; Page loaded in: 0.019 seconds.