Forum

Welcome Guest 

Show/Hide Header

Welcome Guest, posting in this forum requires registration.
Pages: [1]
Author Topic: Stepper moves more than it should TOPIC CLOSED
Raziel
Newbie
Posts: 3
Permalink
Post Stepper moves more than it should
on: March 13, 2017, 16:22

Hello,
i use a elegoo uno and a v1 motorshield.
when i move the gondola in the controller app a little deeper than the homepoint. the steppers move very long time. it is the correct direction but about 10 Times more than it should.
changed the Steps per Rev from 200 to 20.
now is the moving distance correct. but now i can only draw 9 big pixels inside my frame.

i think there is some trouble with my libary´s
Raziel
Newbie
Posts: 3
Permalink
Post Re: Stepper moves more than it should
on: March 14, 2017, 18:39

My Motorshield was the Problem. I got a new shield and new Problems
dealon
Newbie
Posts: 3
Permalink
Post Re: Stepper moves more than it should
on: June 4, 2018, 23:10

Hi!
I have the same problem! I try to start with various combinations:
- 2 different motorshield v1
- 2 different arduino uno ( one of them Chinese analog)
- l298 drivers
- tb6600 drivers
- 2 motor nema 17
- 2 motor 35H20HM-0304A6

I also try to change steps per rev values.
Can anybody help me
dealon
Newbie
Posts: 3
Permalink
Post Re: Stepper moves more than it should
on: June 5, 2018, 17:22

My polargraph now is
- arduino uno
- adafruit motorshield v1
- 2 motor 35h20hm-0304a6 (0.9grad),
- gt2 , pulley 15 teeth

I set steps per rev 400
Mm per rev 30

Result the same:(
Please help

dealon
Newbie
Posts: 3
Permalink
Post Re: Stepper moves more than it should
on: June 5, 2018, 22:01

Omg... problem solved!
1. Multipl parameter
2. Incorrect parameters was uploaded to the arduino.

Pages: [1]
Mingle Forum by cartpauj
Version: 1.0.34 ; Page loaded in: 0.02 seconds.