❓FAQs

📅Update: 2020/08/17
Read the corresponding answer for the frequently asked questions by clicking the page link to the particular topic below or jump to the corresponding page in the LEFT/TOP LEFT navigation list. 
Most Common FAQs
How to re-calibrated DexArm or reset encoder values?
/faq-troubleshooting/faqs/how-to-re-calibrated-dexarm-or-reset-encoder-values
How to upgrade DexArm's firmware?
/faq-troubleshooting/faqs/how-to-upgrade-rotrics-firmware
How to upgrade the touchscreen firmware?
/faq-troubleshooting/faqs/upgrade-touchscreen-firmware
How to send third-party G-code files with Rotrics Studio?
/faq-troubleshooting/faqs/how-to-send-third-party-g-code-files-with-rotrics-studio
How to replace filament?
/faq-troubleshooting/faqs/faq-replace-filament
General
How to upgrade DexArm's firmware?
/faq-troubleshooting/faqs/how-to-upgrade-rotrics-firmware
How to upgrade the touchscreen firmware?
/faq-troubleshooting/faqs/upgrade-touchscreen-firmware
How to re-calibrated DexArm or reset encoder values?
/faq-troubleshooting/faqs/how-to-re-calibrated-dexarm-or-reset-encoder-values
How to send third-party G-code files with Rotrics Studio?
/faq-troubleshooting/faqs/how-to-send-third-party-g-code-files-with-rotrics-studio
How to set Wi-Fi?
/faq-troubleshooting/faqs/how-to-set-wi-fi
How to change touchscreen language?
/faq-troubleshooting/faqs/how-to-change-touchscreen-language
How to execute SD card files?
/faq-troubleshooting/faqs/how-to-execute-sd-card-files
Why can't I copy G-code files to the Touchscreen directly?
/faq-troubleshooting/faqs/why-cant-i-copy-g-code-files-to-the-touchscreen-directly
Writing&Drawing
How to write/draw with different colors?
/faq-troubleshooting/faqs/how-to-write-draw-with-different-colors
Laser Engraving
Why it misses part of the image when drawing?
/faq-troubleshooting/faqs/why-it-misses-part-of-the-image-when-drawing
3D Printing
How to replace filament?
/faq-troubleshooting/faqs/faq-replace-filament
How to level DexArm manually?
/faq-troubleshooting/faqs/how-to-level-dexarm-manually
Why my 3D printing module is clogged?
/faq-troubleshooting/faqs/why-my-3d-printing-module-is-clogged
Teach&Pneumatic
Touchscreen
How to re-calibrated DexArm or reset encoder values?
Last updated 7 months ago